2006 Bigdog Chopper recalls and problems
The 2006 Bigdog Chopper has 6 safety recalls. Recall repairs are free at any Bigdog dealer.
Recalls may cover only some 2006 Bigdog Chopper vehicles. Check your VIN at NHTSA ↗ to see open recalls for your exact car.
2006 Bigdog Chopper recalls
Recall 07V-580: Structure
Problem: On certain motorcycles, the rear fender strut attaching bolts can fail allowing the rear fender to detach from the motorcycle.
Risk: This could occur without prior warning and could result in an injury or a crash.
Fix: Dealers will remove existing strut bolts and replace with higher tensile strength attaching bolts and updated washers. Higher torque values will be observed when installing the replacement fasteners. The recall began on january 21, 2008. Owners may contact big dog at 316-267-9121.
Recall 07V-356: Electrical System
Problem: On certain motorcycles, a warped bus bar within the voltage regulator can cause a short circuit.
Risk: This could possibly result in a fire.
Fix: Dealers will replace the existing circuit breaker located between the voltage regulator positive battery lead (B+ lead) and the positive battery terminal with an alternative circuit protection device that will prevent a thermal event if there is a short to ground. The recall began on october 1, 2007. Owners may contact big dog at 1-316-219-9129 or email to customer.service@bigdogmotorcycles.com.
Recall 06V-389: Structure
Problem: On certain motorcycles, the long pivot bolt may bend or break during normal operation of the motorcycle.
Risk: This could potentially cause the rear fender to abrade against the rear tire while the motorcycle is being driven. This condition could occur without any prior warning and could result in a crash.
Fix: Dealers will replace the long pivot bolt and, if necessary, straighten the rear frame side panel. The short left side pivot bolt and pivot shaft may also be replaced free of charge. The recall began on november 1, 2006. Owners may contact big dog at 316-267-9121.
Recall 06V-305: Electrical System
Problem: On certain motorcycles, the electronic harness control (Ehc) module can fail resulting in a total shut down of the vehicle's electronic power.
Risk: This condition could occur without any prior warning and could result in a crash.
Fix: Dealers will replace the ehc modules free of charge. The recall began on september 19, 2006. Owners may contact big dog at 316-267-9121.
Recall 06V-301: Electrical System
Problem: On certain motorcycles, the ignition modules are oriented within the battery tray in a way that makes the ignition module susceptible to vibration.
Risk: This susceptibility to vibration may contribute to a stalling condition that could occur without any prior warning and result in a crash.
Fix: Dealers will install a new ignition module mounting system free of charge. The recall began on august 25, 2006. Owners may contact big dog at 316-267-9121.
Recall 06V-019: Structure
Problem: On certain motorcycles, the kickstand spring may stretch and detach from the mounting bracket or the kickstand.
Risk: This will allow the kickstand to deploy into the extended position and cause a crash.
Fix: Dealers will install a new kickstand spring free of charge. The recall began on february 17, 2006. Owners may contact big dog at 316-267-9121.
Other Bigdog Chopper years
Frequently asked questions
Does the 2006 Bigdog Chopper have any recalls?
Yes — NHTSA lists 6 recalls for the 2006 Bigdog Chopper: 07V-580 (structure), 07V-356 (electrical system), 06V-389 (structure), 06V-305 (electrical system), 06V-301 (electrical system) and more. Not every vehicle is affected, so check your VIN at nhtsa.gov/recalls.
Are Bigdog recall repairs free?
Yes. Safety recall repairs are free at authorized Bigdog dealers, whether you are the first owner or bought the car used.