Recall 10V-624: 2007–2008 Honda Fit
HONDA (AMERICAN HONDA MOTOR CO.) recall for exterior lighting, reported to NHTSA on Dec 15, 2010, covering about 143,083 vehicles.
The problem
Honda is recalling model year 2007-2008 honda fit vehicles. Due to an error during installation of the wiring harness for the combination switch that controls low head beam function, the wires for the lower beam circuit were pulled tighter than intended. After repeated use of the headlight switch, the electrical connector terminal for the low beam headlight circuit can become worn as a result of this tension, which can result in low conductivity and cause an accumulation of copper oxide in the area of the contacts.
The risk
The low beam headlights can become inoperative decreasing the driver's visibility as well as the vehicle's visibility to other drivers, increasing the risk of a crash.
The fix
Dealers will inspect the low beam terminal and perform necessary repairs free of charge. The safety recall began on january 24, 2011. Owners may contact honda at 1-800-999-1009.
Notes
Honda's safety recall no. R58.owners may also contact the national highway traffic safety administration's vehicle safety hotline at 1-888-327-4236 (Tty 1-800-424-9153), or go to <a href=http://www.safercar.gov>http://www.safercar.gov</a> .
Recall details
| Manufacturer | HONDA (AMERICAN HONDA MOTOR CO.) |
|---|---|
| Component | Exterior Lighting › Headlights › High/Low Beam Dimmer Switch |
| Recall started by | NHTSA (Office of Defects Investigation) |
| NHTSA campaign number | 10V624000 |
Vehicles in this recall
Not every vehicle of these model years is included. Enter your VIN at nhtsa.gov/recalls ↗ or ask a dealer.
Frequently asked questions
What is recall 10V-624?
Honda is recalling model year 2007-2008 honda fit vehicles. Due to an error during installation of the wiring harness for the combination switch that controls low head beam function, the wires for the lower beam circuit were pulled tighter than intended. After repeated use of the headlight switch, the electrical connector terminal for the low beam headlight circuit can become worn as a result of this tension, which can result in low conductivity and cause an accumulation of copper oxide in the area of the contacts.
How is recall 10V-624 fixed?
Dealers will inspect the low beam terminal and perform necessary repairs free of charge. The safety recall began on january 24, 2011. Owners may contact honda at 1-800-999-1009.
Is the recall repair free?
Yes. Safety recall repairs are free at authorized dealers. Check whether your vehicle is included with its VIN at nhtsa.gov/recalls.